This is the most cost-effective process for producing repetitive parts then by machining from stock shapes & also when there is size limitation of injection moulding.

Because of water like viscosity of this monomer (Nylon-6), at minimal pressure, this hot monomer directly polymerizes with a solid nylon shape or part in the tool. Parts of very thick cross-section can be produces without the high stresses induced by injection moulding or extrusion.

• Tooling cost for cast nylon is very low as high strength tool steels are not required because the process is carried out at atmospheric pressure.
• Air voids & sinks is easily avoided in cast nylon parts.
• Possibility of manufacturing large sized stock shapes as well as custom casting which requires only minimal machining.

We produce semi-finished products of Cast Nylon-6 in different qualities. It is heavy duty high ipact wear & heat resistant polyamide.

• 1000 mm x 1000 mm x 10 mm to 100 mm thick

• 50 to 300 mm Dia x 1000 mm long.

About us | Products | Contact us | Feedback | New Products | E-mail | Home

Site created by Web Element